Source: Ningbo Eagle Intelligent Technology Co., Ltd

Do you know the maintenance of vibration discs and their common faults and troubleshooting methods? Here we give you a detailed introduction to this knowledge:
Vibration plate technical parameters as large as there are three: 1, is the top plate size is roughly φ80MM to φ1000MM. 2, is the rated voltage of AC 220V or 110V, the frequency of 50HZHZ, vibration plate according to the need for full-wave excitation or half-wave excitation. 3, is the vibration plate according to customer needs can be divided into clockwise and counterclockwise.
Installation of vibration plate: 1, check the machine and check the machine with the annex to meet the packing list 2, is to check the host parts of the firmware is loose. 3, must be installed so that the vibration-damping components in the corresponding position. 4, is the vibration plate height and level adjustment, the base of solid fixed on the fixed plate or bracket. 5, is the vibration plate outlet connection between the equipment to leave the appropriate gap, so as not to affect the normal operation of the vibration plate. 6, is connected with the electrical control box vibration plate electrical plug, turn on the power, turn on the switch, slowly turn the potentiometer, and gradually reach the required number of feeding can be. Finally, it is important to note that the potentiometer must be transferred to the minimum value before starting, so as not to damage the SCR.
Vibration disk common faults and troubleshooting methods have the following: Turn on the power does not vibrate, to check the electrical controller fuse is broken, the electrical components are loose, plug socket is bad. If the delivery speed can not meet the requirements and pay attention to the following three; 1, check the fastening of the elastic components of the screws are loose. 2, the spring is broken. 3, the electromagnetic gap is too large, the normal gap corresponding to the small vibration plate of the electromagnet and the armature spacing in the 0.5MM to 1.2MM range. Core and armature face unevenness is not greater than 0.02MM. two. Electromagnet coil temperature is high or burn the coil has 2 points: 1, between the electromagnetic and the armature is too large, easy to burn the coil. 2, adapted to full-wave vibration of the electromagnet If the half-wave power supply will appear high temperature. These are the application and maintenance of vibration discs, and may not expect improvement.

Recommended products Keywords: Cixi vibration plate Ningbo vibration plate non-standard vibration plate