First, the controller vibration plate connected to the 220V voltage, if the indicator does not light, then check the controller outside the fuse position, the fuse is not lacking.
Second, the controller connected to the 220 voltage, adjust the speed of rotation switch, is not the direction of rotation, investigate the speed of the vibration plate, and gradually become faster, so that the vibration plate to reach the customer requirements rate of more than 20% If the voltage is unstable, the vibrating disc will appear as soon as possible.
Third, the vibration plate Disposable pieces can be made by disk size, such as sensation in the workpiece did not cover the chassis, immediately feeding.
Fourth, in the sensation of the operation if the speed of rotation switch rotation, the operation is still walking, please immediately stop, check the chassis is not faulty. If the chassis does not go is probably the following reasons:
1, the spring has a crack appearance;
2, there are loose bolts;
3, spring pieces need to conditioning from scratch.
Solution:
1, replace the spring can be;
2, tighten the bolt can be;
3, conditioning spring pieces.
Note: the method of conditioning the spring, the group of spring set of any one of them, a little loosening of the bolt to investigate the speed of the vibration plate is not changed, the need to change the spring is thin, slow need to spring Replaced by thick, according to this approach can be sensational disk conditioning to the required speed requirements.
1, active accessories barrels, in order to save still accessories special planning, can take the initiative to the vibration plate accessories, the material more or less adjustable the size of the switch.
2, photoelectric switch, when the induction to the feed trajectory when the material will take the initiative to let the vibration plate to stop, when the air when the vibration plate and then start, empty, full of time lights factory warning lights, can save electricity, extend the use of vibration plate life.
3, feeding control switch, when the induction to the vibration plate is expected, will take the initiative to let the auxiliary bucket down to the vibration plate.
4, linear feeder, to connect the vibration plate and the trajectory of the machine interval, so that more cutting material, not easy card material.