1. Confirm that the vibrating body is locked on the disk;
2. Adjust the controller button to the middle position or tune to numbers 130 to 180;
3. Turn on the power to see if the speed of the vibration plate is reached;
4. If you do not meet the requirements, do not turn off the power, will lock the shrapnel of the fixed screw loose any one, see the vibration speed changes;
5. If the shrapnel fixing screw, the vibration speed becomes faster, it means that the shrapnel is too thick, the number of shrapnel or the thickness of the shrapnel is appropriately reduced and then proceed to step 4,
6. If the loose pieces of fixed screw, vibration speed slows down, then the shrapnel is too thin, moderate increase in the number or thickness of shrapnel, and then step 4, again debugging;
7. If the adjustment of step 4, the vibration speed is not changed, it means that the shrapnel has been completed;
8. Electromagnets to be aligned, the gap in the 1-1.5 mm, the gap should be parallel. |
Record: ICP.17021542
